External 12V power for programmer powering in OBD mode!!!
USB powering ONLY !!!
For Toyota Flasher, a joint project by Autokey and P.C.M.flash, is a multipurpose programmer for Denso and Fujitsu Ten ECUs with NEC processors installed For TOYOTA/LEXUS/SCION vehicles with petrol and diesel engines through JTAG interface. OBD writing via CAN bus is supported. It is a unique solution in the chip tuning world. It covers almost all the models beginning from 2003-2004. It can read, flash, clear, verificate internal flash memory of microcontrollers if connected to the appropriate connector on the ECU circuit board.
·Its own hardware interface allows to avoid all compatibility and driver problems;
·Work through built-in 20 or 26 pin JTAG connector;
·Full access to the ECU memory at high speed of more than 100 KB/s;
·Saving files in the open format;
·Firmware checksum verification and recalculation.
·SUPPORT 2015 + OBD WRITE and SOME MODELS 2015 + OBD READ
·can READ and WRITE via internal 20 pin or 26 pin connector. connection diagram for all known
For TOYOTA DENSO ENGINE CONTROL MODULE based on NEC 7F00XX series MCU:
saving in normal mode without any master-slave.
auto CHECKSUM CORRECTION support
These processors were introduced at the beginning of CAN support and as a rule with coachwork change.
1pc* ECU Flash main unit
1pc* 12V/3A power out
1pc* 16pin cable for ecu reading by OBD
1pc* cable for BDM function
1pc* adapter for Mitsubshi reading by boot
1pc* USB cable to connect the tool to the computer
Tel: 86 15827411186
Whatsapp: 86 15827411186